ASTM B921-08(2023) PDF

ABSTRACT This specification covers the requirements relating to rinsed and non-rinsed non-hexavalent chromium conversion coatings on aluminum and aluminum alloys intended to retard corrosion; as a base for organic films including paints, plastics, and adhesives; and as.a protective coating having a low electrical contact impedance. Coatings are categorized into four classes according to corrosion protection and finish. The type of conversion coating depends on the composition of the solution and may also be affected by pH, temperature, duration of the treatment, and the nature and surface condition. Films are normally applied by dipping, but may also be applied by inundation, spraying, roller coating, or by wipe-on techniques. Coatings shall adhere to specified electrical resistance, adhesion, and corrosion resistance requirements. SCOPE 1.1 This specification covers the requirements relating to rinsed and non-rinsed non-hexavalent chromium conversion coatings on aluminum and aluminum alloys intended to give protection against corrosion and as a base for other coatings. 1.2 Aluminum and aluminum alloys are conversion coated in order to retard corrosion; as a base for organic films including paints, plastics, and adhesives; and as a protective coating having a low electrical contact impedance. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.