Standard Test Method for Vanadium in Paint Driers by EDTA Method
Standard Test Method for Vanadium in Paint Driers by EDTA Method
SIGNIFICANCE AND USE 4.1 This test method may be used to confirm the stated content of a pure liquid vanadium drier manufactured for use by the coatings industry. SCOPE 1.1 This test method covers the titrimetric determination of vanadium in liquid vanadium driers and utilizes the disodium salt of ethylenediaminetetraacetic acid dihydrate (EDTA). 1.2 This test method is limited to the determination of the vanadium content of a liquid vanadium drier that does not contain other drier elements. This test method is not applicable to drier blends. 1.3 All cations that can be titrated with EDTA in alkaline media interfere and must not be present in the sample. 1.4 This test method has been tested for concentrations of 3 % and 4 % vanadium, but there is no reason to believe that it is not suitable for higher or lower vanadium concentrations provided specimen size is adjusted proportionately. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D3988-05(2023), titled Standard Test Method for Vanadium in Paint Driers by EDTA Method, establishes a standardized titrimetric procedure for quantifying vanadium content in liquid vanadium paint driers. The method uses the disodium salt of ethylenediaminetetraacetic acid dihydrate (EDTA) to determine vanadium concentration and is directly applicable to the coatings industry for quality control and material verification. Developed by ASTM, this internationally recognized standard supports the consistent production and verification of pure liquid vanadium driers.
This standard is essential for:
Другие стандарты ASTM
For comprehensive quality and procedural alignment, consult these associated standards:
Keywords: Vanadium, paint driers, EDTA titration method, coatings industry, ASTM D3988-05, liquid drier analysis, quality control, vanadium determination, reagent standardization, industrial standards.