ASTM D5675-13(2023) PDF

ABSTRACT This classification system provides a method of adequately identifying PTFE micropowders using a system consistent with that also of another specific classification. These powders are sometimes known as lubricant powders which usually have a much smaller particle size than those used for molding or extrusion. The test methods and properties included are those required to identify and specify the various types of fluoropolymer micropowders. This classification covers two groups of fluoropolymer micropowders. Fluoropolymer micropowders are classified into groups according to their base fluoropolymer. These groups are further subdivided into classes and grades. Different tests shall be performed in order to determine the following properties of the micropowders: melting characteristics, melt flow rate, specific gravity, water content, particle size, surface area, and bulk density. SCOPE 1.1 This classification system provides a method of adequately identifying low molecular weight polytetrafluoroethylene (PTFE) and fluorinated ethylene propylene (FEP) micronized powders using a system consistent with that of Classification System D4000. It further provides a means for specifying these materials by the use of a simple line callout designation. This classification covers fluoropolymer micronized powders that are used as lubricants and as additives to other materials in order to improve lubricity or to control other characteristics of the base material. 1.2 These powders are sometimes known as lubricant powders. The powders usually have a much smaller particle size than those used for molding or extrusion, and they generally are not processed alone. The test methods and properties included are those required to identify and specify the various types of fluoropolymer micronized powders. Recycled fluoropolymer materials meeting the detailed requirements of this classification are included (see Guide D7209). 1.3 These fluoropolymer micronized powders and the materials designated as filler powders (F) in ISO 12086-1 and ISO 12086-2 are equivalent.2 1.4 The values stated in SI units as detailed in IEEE/ASTM SI-10 are to be regarded as the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 7.1.2. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.