ASTM D7026-04 PDF

SCOPE 1.1 This guide provides a framework for collecting and handling samples for determination of biobased content of materials by means of the carbon isotope method described in Test Methods D 6866. Tests for sampling adequacy based on the standard statistical tools are provided. In addition, reporting of the results, including sampling techniques and handling procedures and chain-of-custody issues are discussed. 1.2 This guide is concerned with collecting representative samples within a given material or a lot, not with lot-to-lot variations such as considered in quality control schemes. 1.3 Biobased materials often represent sampling problems specific to a given material, such as heterogeneity, and so forth, which require employment of material-specific sampling methods. The use of specialized sampling methods already accepted and validated by industries that manufacture and/or use the biomaterial is encouraged. However, all sampling techniques, especially non-standard techniques developed for specific materials must be reported in sufficient detail to allow critical assessment of the techniques used. 1.4 Carbon isotope analysis involves thermal processing in presence of oxidants. Compatibility of any given material with Test Methods D 6866 must be assessed. Special attention must be given to materials with potential for explosion hazards, such as peroxides, nitrated compounds, azides, and so forth. Examples of peroxide-forming compounds are ethers, some ketones and a number of other compounds. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. Note 1—There is no similar or equivalent ISO standard. WITHDRAWN RATIONALE This guide provided a framework for collecting and handling samples for determination of biobased content of materials by means of the carbon isotope method described in Test Methods . Tests for sampling adequacy based on the standard statistical tools were provided. In addition, reporting of the results, including sampling techniques and handling procedures and chain-of-custody issues were discussed. Formerly under the jurisdiction of Committee D20 on Plastics, this guide was withdrawn in January 2013 in accordance with section 10.6.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.