ASTM E3105-17(2023) PDF

ABSTRACT This specification prescribes the performance criteria for non-removable permanent coatings and fixatives as a long-term measure used to immobilize radioactive contamination, minimize worker exposure, and protect uncontaminated areas against the spread of radioactive contamination. It covers the minimum performance requirements (shelf life, adhesion, abrasion resistance, dry/cure time, decontamination factor, airborne release fraction, respirable fraction, radiation resistance) as well as the mechanical and chemical properties for permanent coatings that are intended to immobilize dispersible radioactive contamination deposited on buildings and equipment as might result from anticipated to unanticipated events to include normal operating conditions, decommissioning, and radiological release. The coating is intended to reduce: migration of the contamination into or along buildings, equipment, and other surfaces; resuspension of contamination into the air; and the spread of contamination as a result of external forces such as pedestrian traffic. It shall: be applicable to both vertical and horizontal surfaces; work within a range of environmental and radiological conditions; and be applicable to both porous and nonporous materials such as concrete, wood, metal, ceramics, and plastics. Furthermore, the coating may include constituents that will physically or chemically bind and hold radioactive contamination. SCOPE 1.1 This specification is intended to provide a basis for identification of non-removable permanent coatings and fixatives as a long-term measure used to immobilize radioactive contamination, minimize worker exposure, and to protect uncontaminated areas against the spread of radioactive contamination. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.