ASTM F2220-15(2023) PDF

ABSTRACT This specification covers the materials, sizing, and manufacturing details of test headforms for use in the testing of protective headgear. This specification identifies the requirements for five test headform size codes: A, E, J, M, and O. All datum levels shall be quoted relative to the reference plane. The headforms shall be symmetrical about the midsagittal plane. Internal geometry may be defined to satisfy the requirements of the individual test specifications. The impact headforms shall be made of K1A-F magnesium, with the prescribed zirconium and magnesium composition, and shall conform to the specified requirements for: external dimensions, performance (resonant frequency), mass, and center of gravity. All impact headforms shall be marked with: headform size, basic plane, reference plane, and midsagittal (longitudinal) and coronal (transverse) planes through the vertical axis. Other headforms shall be made of material of sufficient strength and stiffness to maintain their geometry during testing and shall comply to the external dimension requirements. SCOPE 1.1 This standard specifies the materials, sizing, and manufacturing details of test headforms for use in the testing of protective headgear. Details of the exterior dimension of the headforms are included. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.