ASTM F790-23 PDF

SIGNIFICANCE AND USE 3.1 This guide is intended for use by material suppliers, aircraft transparent enclosure fabricators, air-frame manufacturers, government agencies, and others that may become involved in the testing of transparency components. These test methods provide data on both individual materials and material combinations commonly utilized in the fabrications of aerospace transparent enclosures comprised of monolithic plastic, coated monolithic plastic or laminated constructions containing plastics. 3.2 Primary properties and their long term stability are critical to the performance of aerospace transparent enclosures. Property measurement tests define as-manufactured material properties of these materials. Aging procedures provide for exposure of parts or representative sections to environments that induce changes in material properties as determined in property measurement tests. Property measurement tests performed before and after aging exposure provide a means of estimating the potential usable life span of a transparency or to compare the durability of one material with another. 3.3 When employing these test methods for comparison of materials for weathering effects the user should be aware that the many factors influencing degradation due to weathering vary from one location to another. For direct weathering comparisons, all material(s) shall undergo exposure conditions and property measurements testing at the same time. 3.4 The test methods listed include those considered critical to the performance of aircraft transparent enclosures. Other test methods to evaluate materials shall also be performed where necessary. Additional test methods are in preparation and will be incorporated. The user is advised to employ the latest revision of any test method. 3.5 The dominant component of all transparent enclosures is one, or more, rigid transparent sheet(s). The sheet(s) must permit the necessary visibility while providing structural integrity and protecting the ... SCOPE 1.1 This guide is intended to summarize the standard test methods available on individual and composite materials utilized in fabrication of aerospace plastic transparent enclosures. As such, it is intended to specifically include transparent thermoplastics, transparent elastomers, and reinforced plastics, whether thermoplastic or thermosetting. 1.2 This guide is intended as an aid in the search for test methods pertinent to Aerospace Plastic Transparent Enclosures. It should be understood that all methods listed may not apply to all enclosures. 1.3 The standards included refer to the properties or aspects listed in Table 1. The properties or aspects are listed in alphabetical order and the descriptions used are intended to facilitate the search. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.