BS EN 10326:2004 PDF

BS EN 10326:2004 specifies requirements for continuously hot-dip coated products made of structural steels coated with zinc (Z), zinc-iron alloy (ZF), zinc-aluminium alloy (ZA), aluminium-zinc alloy (AZ) and aluminium-silicon alloy (AS) with thicknesses from 0.35 mm up to 3.0 mm unless otherwise agreed. The thickness is the final thickness of the delivered product after coating. This standard applies to strip of all widths and to sheets cut from it (greater than or equal to 600 mm width) and cut lengths (< 600 mm width). This standard may also be applied to continuously hot-dip coated flat products in thicknesses > 3.0 mm. The products covered by this standard are mainly used where minimum yield strength and corrosion resistance are the most important factors. This standard is not applicable to: