BS EN 61558-2-10:2014 PDF

Safety of transformers, reactors, power supply units and combinations thereof - Particular requirements and tests for separating transformers with high insulation level and separating transformers with output voltages exceeding 1 000 V

Название (английский):

BS EN 61558-2-10:2014

Статус документа:: Отменён
Формат:: Электронный (PDF)
Дата публикации:: 31 августа 2014 г.
ICS:: 29.180
Технический комитет:: CENELEC
SKU:: BS EN 61558-2-10:2014

Тип поставки:

Full version50 €Read online 24h10 €Read online 72h15 €

Язык документа:

ruen

Срок поставки:1 раб. дн. (перевод)

Цена:50 €

Abstract

1 Scope

Replacement:

This part of IEC 61558 deals with the safety of separating transformers with high insulation level and separating transformers with output voltages exceeding 1 000 V. Transformers incorporating electronic circuits are also covered by this standard.

NOTE 1 Safety includes electrical, thermal and mechanical aspects.

Unless otherwise specified, from here onward, the term transformer covers separating transformers with high insulation level and separating transformers with output voltages exceeding 1 000 V a.c or 1 500 V d.c . This Part 2-10 is applicable to stationary or portable , single-phase or polyphase, air-cooled (natural or forced) independent or associated dry-type transformers. The windings may be encapsulated or non-encapsulated. This standard is applicable to transformers and power supply (linear) with internal operational frequencies not exceeding 500 Hz. This standard used in combination with Part 2-16 for switch mode power supply units ( SMPS ) is also applicable to power supplies with internal operational frequencies higher than 500 Hz. Where the two requirements are in conflict the most severe take precedence. The rated supply voltage does not exceed 1 000 V a.c., and the rated supply frequency and the internal operating frequency do not exceed 500 Hz. The rated output does not exceed: ...

BS EN 61558-2-10:2014 PDF

Abstract

Похожие стандарты

Abstract

Похожие стандарты

Corrigendum 1 - Safety of transformers, reactors, power supply units and combinations thereof - Part 2-16: Pa…

Aerospace series. Circuit breakers. Test methods. Performance with a locked tripping system.

Information technology. Electronic discovery. Technical readiness.

Test conditions for machining centres. Accuracy and repeatability of positioning of linear and rotary axes.

Aerospace series. Acrylonitrile-butadiene rubber (NBR). Low temperature resistant. Hardness 60 IRHD.

Mountaineering equipment. Frictional anchors. Safety requirements and test methods.

Health Informatics. General purpose information components. Non-clinical.

Ambient air. Standard method for the measurement of the concentration of carbon monoxide by non-dispersive in…