BS EN ISO 12004-2:2008 PDF
Metallic materials. Sheet and strip. Determination of forming-limit curves - Determination of forming-limit curves in the laboratory
Metallic materials. Sheet and strip. Determination of forming-limit curves - Determination of forming-limit curves in the laboratory
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 30 ноября 2008 г.
- ICS:
- 77.040.10
- Технический комитет:
- CEN
- SKU:
- BS EN ISO 12004-2:2008
Abstract
1 Scope This part of ISO 12004 specifies the testing conditions to be used when constructing a forming-limit curve (FLC) at ambient temperature and using linear strain paths. The material considered is flat, metallic and of thickness between 0,3 mm and 4 mm.
NOTE The limitation in thickness of up to 4 mm is proposed, giving a maximum allowable thickness to the punch diameter ratio.
For steel sheet, a maximum thickness of 2,5 mm is recommended.
Похожие стандарты
Упомянутые в описании и другие стандарты BS