1 Scope

1.1 This International Standard specifies a method for the determination of the indentation hardness of plastics and ebonite by means of durometers of two types: type A is used for softer materials and type D for harder materials (see the Note to 8.2). The method permits measurement either of the initial indentation or of the indentation after a specified period of time, or both.

NOTE The durometers and the methods specified in this International Standard are referred to as type A Shore and type D Shore durometers and durometer methods, respectively.

BS EN ISO 868:2003 PDF

Abstract

Похожие стандарты

BS EN 3841-307:2004

Aerospace series. Circuit breakers. Test methods. Performance with a locked tripping system.

BS ISO/IEC 27050-4:2021

Information technology. Electronic discovery. Technical readiness.

BS ISO 10791-4:1998

Test conditions for machining centres. Accuracy and repeatability of positioning of linear and rotary axes.

BS EN 3697:2013

Aerospace series. Acrylonitrile-butadiene rubber (NBR). Low temperature resistant. Hardness 60 IRHD.

BS EN 12276:2013

Mountaineering equipment. Frictional anchors. Safety requirements and test methods.

BS EN 14822-2:2005

Health Informatics. General purpose information components. Non-clinical.

BS EN 14626:2024

Ambient air. Standard method for the measurement of the concentration of carbon monoxide by non-dispersive in…

BS ISO/IEC 19678:2015

Information Technology. BIOS Protection Guidelines.