BS EN IEC 61280-2-13:2024
Fibre optic communication subsystem test procedures - Digital systems. Measurement of error vector magnitude
Fibre optic communication subsystem test procedures - Digital systems. Measurement of error vector magnitude
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Дата публикации:
- 30 ноября 2024 г.
- ICS:
- 33.180.10
- Технический комитет:
- CENELEC
- SKU:
- BS EN IEC 61280-2-13:2024
Abstract
1 Scope This part of the IEC 61280‑2 series defines a procedure for calculating the root-mean-square error vector magnitude of optical n -APSK signals from a set of measured symbols. It specifically defines the normalization of the reference states and a procedure for optimal scaling of the measured symbol states. The procedure described in this document applies to single-polarized optical signals as well as to conventional polarization-multiplexed signals with independently modulated polarization tributaries. In general, it is not advisable to apply these procedures without modification to signals, in which optical amplitude, phase, and polarization state are simultaneously modulated to encode the information data. This document does not specify any signal processing steps for extracting the symbols from the received optical signals, because these steps depend on the optical receiver and can vary with the type of the transmitted n -APSK signal. These and optional additional signal processing steps are defined in application-specific documents.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
IEC 61280-2-3:2009
ДействующийFibre optic communication subsystem tets procedures - Part 2-3: Digital systems - Jitter and wander measureme…
Overview IEC 61280-2-3:2009 is an international standard developed by the International Electrotechnical Commission (IEC). It specifies standardized test procedures for measuring jitter and wander in…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…