BS EN IEC 61400-6:2020
Wind energy generation systems - Tower and foundation design requirements
Wind energy generation systems - Tower and foundation design requirements
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Дата публикации:
- 31 декабря 2020 г.
- ICS:
- 27.180
- SKU:
- BS EN IEC 61400-6:2020
Abstract
1 Scope This part of IEC 61400 specifies requirements and general principles to be used in assessing the structural integrity of onshore wind turbine support structures (including foundations). The scope includes the geotechnical assessment of the soil for generic or site specific purposes. The strength of any flange and connection system connected to the rotor nacelle assembly (including connection to the yaw bearing) are designed and documented according to this document or according to IEC 61400‑1. The scope includes all life cycle issues that may affect the structural integrity such as assembly and maintenance. The assessment assumes that load data has been derived as defined in IEC 61400‑1 or IEC 61400‑2 and using the implicit reliability level and partial safety factors for loads.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
IEC 61400-27-1:2015
ДействующийWind turbines - Part 27-1: Electrical simulation models - Wind turbines
Overview IEC 61400-27-1:2015 is an international standard published by the International Electrotechnical Commission (IEC) that defines electrical simulation models for wind turbines. This part 27-1…
IEC 61400-12-1:2017
ДействующийWind energy generation systems - Part 12-1: Power performance measurements of electricity producing wind turb…
Overview IEC 61400-12-1:2017 - "Wind energy generation systems - Part 12-1: Power performance measurements of electricity producing wind turbines" is the international procedure for measuring and rep…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…