BS EN ISO 12625-16:2015
Tissue paper and tissue products - Determination of optical properties. Opacity (paper backing). Diffuse reflectance method
Tissue paper and tissue products - Determination of optical properties. Opacity (paper backing). Diffuse reflectance method
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 28 февраля 2015 г.
- ICS:
- 85.060
- Технический комитет:
- CEN
- SKU:
- BS EN ISO 12625-16:2015
Abstract
1 Scope This part of ISO 12625 specifies the testing procedures for the instrumental determination of the opacity of tissue paper or tissue products by diffuse reflectance using a paper backing. This part of ISO 12625 contains specific instructions for the preparation of test pieces of single-ply and multi-ply products, where special preparation/procedures might be necessary. It can be used to determine the opacity of tissue paper and tissue products containing fluorescent whitening agents, provided the UV content of the radiation incident on the test piece has been adjusted to conform to that in the CIE illuminant C using a fluorescent reference standard provided by an authorized laboratory as described in ISO 2470‑1. This part of ISO 12625 is not applicable to coloured tissue paper and tissue products which incorporate fluorescent dyes or pigments.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 12625-18:2022
ДействующийTissue paper and tissue products — Part 18: Determination of surface friction
Overview ISO 12625-18:2022 specifies a laboratory test method for determining the surface friction of tissue paper and tissue products using a contact-type surface tester. The method measures the coe…
BS ISO 2470-1:2016
ДействующийPaper, board and pulps. Measurement of diffuse blue reflectance factor. Indoor daylight conditions (ISO brigh…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…