BS EN ISO 2106:2011
Anodizing of aluminium and its alloys. Determination of mass per unit area (surface density) of anodic oxidation coatings. Gravimetric method
Anodizing of aluminium and its alloys. Determination of mass per unit area (surface density) of anodic oxidation coatings. Gravimetric method
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 31 марта 2011 г.
- ICS:
- 25.220.20
- Технический комитет:
- CEN
- SKU:
- BS EN ISO 2106:2011
Abstract
1 Scope This International Standard specifies a gravimetric method for determining the mass per unit area (surface density) of anodic oxidation coatings on aluminium and its alloys. The method is applicable to all oxidation coatings formed by anodizing aluminium and its alloys, either cast or wrought, and is suitable for most aluminium alloys, except those in which the copper content is greater than 6 %.
NOTE 1 A high content of copper in the alloy can lead to increased dissolution of the basis aluminium.
NOTE 2 If the thickness is known with sufficient precision (for example, using the method specified in [ISO 2128](/search?q=ISO%C2%A02128)), determination of the mass per unit area (surface density) of the coatings will enable its apparent density to be calculated. Conversely, if the conditions of application of the coating and its density are known, the determination of its mass per unit area (surface density) can permit calculation of the average mass and an approximate evaluation of the thickness (see the Note in Clause 6).
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 21281:2005
ДействующийConstruction and layout of pedals of self-propelled sit-down rider-controlled industrial trucks — Rules for t…
Overview ISO 21281:2005 is an international standard that specifies the construction and layout of pedals used in self-propelled sit-down rider-controlled industrial trucks, such as forklifts. Develo…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…