BS EN ISO 5263-2:2004
Pulps. Laboratory wet disintegration - Disintegration of mechanical pulps at 20°C
Pulps. Laboratory wet disintegration - Disintegration of mechanical pulps at 20°C
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Дата публикации:
- 30 апреля 2007 г.
- ICS:
- 85.040
- Технический комитет:
- CEN
- SKU:
- BS EN ISO 5263-2:2004
Abstract
1 Scope This part of ISO 5263 specifies an apparatus and the procedures for the laboratory-wet disintegration of mechanical pulps that do not exhibit latency or mechanical pulps where latency has already been removed. This apparatus and procedure are required for preparation of the test portion in a number of other International Standards dealing with pulps. In principle, this method is applicable to all kind of mechanical pulps (i.e. mechanical, semi-chemical and chemi-mechanical pulps) that do not exhibit latency , including recovered fibres from mechanical pulps. It is not suitable for mechanical pulps exhibiting latency for which the disintegration procedure described in ISO 5263-3 shall be used. The procedure specified by ISO 5263-2 should also be used to disintegrate all mechanical pulps to be measured for brightness.
NOTE Brightness is not significantly altered by the presence of latency ; however, hot disintegration of mechanical pulps can lead to significant loss of brightness.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 5263-2:2004
ДействующийPulps — Laboratory wet disintegration — Part 2: Disintegration of mechanical pulps at 20 degrees C
Overview ISO 5263-2:2004 - "Pulps - Laboratory wet disintegration - Part 2: Disintegration of mechanical pulps at 20 °C" specifies equipment and procedures for reproducible wet disintegration of mech…
ISO 5263-3:2004
ОтменёнPulps — Laboratory wet disintegration — Part 3: Disintegration of mechanical pulps at > 85 degrees C
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…