BS EN ISO 6145-1:2008
Gas analysis. Preparation of calibration gas mixtures using dynamic volumetric methods - Methods of calibration
Gas analysis. Preparation of calibration gas mixtures using dynamic volumetric methods - Methods of calibration
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 11 октября 2004 г.
- ICS:
- 71.040.20
- Технический комитет:
- CEN
- SKU:
- BS EN ISO 6145-1:2008
Abstract
BS EN ISO 6145-1:2008 Gas analysis. Preparation of calibration gas mixtures using dynamic volumetric methods. Methods of calibration
BS EN ISO 6145-1 specifies the calibration methods involved in the preparation of gas mixtures by dynamic volumetric techniques. It also gives a brief presentation of a non-exhaustive list of examples of dynamic volumetric techniques. These techniques are described in more detail in other parts of ISO 6145
Contents of BS EN ISO 6145-1
Introduction Scope Normative references Terms and definitions Calibration methods General Description of primary or potentially primary measuring devices Measurements on the final mixture Techniques for preparation of gas mixtures calibrated by the methods described in Clause 4 General Volumetric pumps Continuous injection Capillary Critical orifices Thermal mass flow controllers Diffusion Saturation Permeation Volume measurement by weighing the water content Description of secondary devices which need calibration against primary devices Bibliography
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 6145-11:2005
ДействующийGas analysis — Preparation of calibration gas mixtures using dynamic volumetric methods — Part 11: Electroche…
Overview ISO 6145-11:2005 - Gas analysis: Preparation of calibration gas mixtures using dynamic volumetric methods - Part 11: Electrochemical generation - specifies a standardized method to prepare c…
ISO 6145-7:2018
ДействующийGas analysis — Preparation of calibration gas mixtures using dynamic methods — Part 7: Thermal mass-flow cont…
Overview ISO 6145-7:2018 specifies a dynamic method for the continuous preparation of calibration gas mixtures using thermal mass‑flow controllers (TMCs). The standard applies to mixtures of non‑reac…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…