BS EN ISO 6145-1:2019
Gas analysis. Preparation of calibration gas mixtures using dynamic methods - General aspects
Gas analysis. Preparation of calibration gas mixtures using dynamic methods - General aspects
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Дата публикации:
- 31 октября 2019 г.
- ICS:
- 71.040.20
- SKU:
- BS EN ISO 6145-1:2019
Abstract
What is ISO 6145-1 - Preparation of calibration gas mixtures using dynamic methods about?
ISO 6145-1 is the first part of the multi-series standard that is applicable to the preparation of calibration gas mixtures using dynamic methods.
ISO 6145-1 gives a brief overview of each of the dynamic techniques which are described in detail in the subsequent parts of ISO 6145 .
ISO 6145-1 provides basic information to support an informed choice for one or another method for the preparation of calibration gas mixtures. It also describes how these methods can be linked to national measurement standards to establish metrological traceability for the composition of the prepared gas mixtures. <span data-ccp-props='{"201341983...
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 6145-11:2005
ДействующийGas analysis — Preparation of calibration gas mixtures using dynamic volumetric methods — Part 11: Electroche…
Overview ISO 6145-11:2005 - Gas analysis: Preparation of calibration gas mixtures using dynamic volumetric methods - Part 11: Electrochemical generation - specifies a standardized method to prepare c…
ISO 6145-7:2018
ДействующийGas analysis — Preparation of calibration gas mixtures using dynamic methods — Part 7: Thermal mass-flow cont…
Overview ISO 6145-7:2018 specifies a dynamic method for the continuous preparation of calibration gas mixtures using thermal mass‑flow controllers (TMCs). The standard applies to mixtures of non‑reac…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…