BS EN ISO 6802:2018
Rubber or plastics hoses and hose assemblies. Hydraulic impulse test with flexing
Rubber or plastics hoses and hose assemblies. Hydraulic impulse test with flexing
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Дата публикации:
- 31 октября 2018 г.
- ICS:
- 23.040.70
- Технический комитет:
- CEN
- SKU:
- BS EN ISO 6802:2018
Abstract
What is this standard about?
This document describes hose impulse testing, with flexing, of rubber or plastics hydraulic hose assemblies at both high and low impulse pressures. The high-pressure testing is carried out at pressures greater than 3 MPa and the low-pressure testing at pressures from 1,5 MPa to 3 MPa. The test procedure is applicable to hydraulic hose assemblies that are subject to pulsating pressures in service which are included in the product requirements.
NOTE Impulse test procedures without flexing can be found in ISO 6803.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 6803:2017
ДействующийRubber or plastics hoses and hose assemblies — Hydraulic-pressure impulse test without flexing
Overview ISO 6803:2017 specifies a standardized procedure for hydraulic-pressure impulse testing without flexing of rubber or plastics hoses and hose assemblies. It covers both high-pressure testing…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…