BS EN ISO 6847:2020
Welding consumables. Deposition of a weld metal pad for chemical analysis
Welding consumables. Deposition of a weld metal pad for chemical analysis
- Статус документа:
- D
- Формат:
- Электронный (PDF)
- Дата публикации:
- 30 сентября 2020 г.
- ICS:
- 25.160.20
- SKU:
- BS EN ISO 6847:2020
Abstract
What is ISO 6847 about?
ISO 6847 is an international standard that covers specifications for welding consumables. ISO 6847 specifies the procedure to be used for the deposition of a weld metal pad for chemical analysis. ISO 6847 applies to deposition of a weld metal pad by use of covered electrodes, wire electrodes for gas shielded metal arc welding, tubular cored electrodes for gas shielded metal arc welding and for non-gas shielded metal arc welding, solid rods and tubular cored rods for gas tungsten arc welding, and wire-flux and strip-flux combinations for submerged arc welding or electroslag welding and cladding. Note 1: ISO 6847 is applicable to welding consumables for non-alloy and fine grain steels, high strength steels, creep-resisting steels, stainless and heat-resisting steels, nickel and nickel alloys, and copper and copper alloys.
Who is ISO 6847 for?
ISO 6...
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 6847:2020
ДействующийWelding consumables — Deposition of a weld metal pad for chemical analysis
Overview ISO 6847:2020 is an international standard developed by ISO that specifies the procedure for depositing weld metal pads intended for chemical analysis. This standard applies to a comprehensi…
ISO 6164:2018
ДействующийHydraulic fluid power — Four-screw, one-piece square flange connections for use at pressures of 42 MPa, DN 25…
Overview ISO 6164:2018 specifies four-screw, one-piece square flange connections for hydraulic fluid power systems rated at 42 MPa (420 bar) for nominal sizes DN 25 to DN 80. The standard defines gen…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…