BS EN ISO 8745:1998
Grooved pins. Half-length taper grooved
Grooved pins. Half-length taper grooved
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 15 мая 1998 г.
- ICS:
- 21.060.50
- Технический комитет:
- CEN
- SKU:
- BS EN ISO 8745:1998
Abstract
1 Scope This International Standard specifies the characteristics of half-length taper grooved pins made of steel or austenitic stainless steel which have three equally spaced grooves impressed longitudinally on their exterior surface, with nominal diameter, d 1 , from 1,5 mm to 25 mm inclusive. The displaced material to each side of the grooves forming an expanded diameter, d 2 , which is larger than the nominal diameter d 1 will cause a non-positive locking fit when these grooved pins are forced into a drilled hole equal to the nominal diameter d 1 , (see clause 4 ).
Похожие стандарты
Другие стандарты BS
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…