BS EN ISO 9377-2:2000
Water quality. Determination of hydrocarbon oil index - Method using solvent extraction and gas chromatography
Water quality. Determination of hydrocarbon oil index - Method using solvent extraction and gas chromatography
- Статус документа:
- D
- Формат:
- Электронный (PDF)
- Дата публикации:
- 15 декабря 2000 г.
- ICS:
- 13.060.50
- Технический комитет:
- CEN
- SKU:
- BS EN ISO 9377-2:2000
Abstract
1 Scope This part of ISO 9377 specifies a method for the determination of the hydrocarbon oil index in waters by means of gas chromatography. The method is suitable for surface water, waste water and water from sewage treatment plants and allows the determination of a hydrocarbon oil index in concentrations above 0,1 mg/l. The method is not applicable to the quantitative determination of the content of volatile mineral oil. However, on the basis of the peak pattern of the gas chromatogram, certain qualitative information on the composition of the mineral oil contamination can be derived.
NOTE 1 For the determination of the mineral-oil content of soils and sediment, see [ISO/TR 11046](/search?q=ISO%2FTR%C2%A011046).
NOTE 2 The mass concentration of animal and vegetable fat in the test sample should not exceed
150 mg/l, because at higher values the adsorption capacity of the clean-up column
packing may not be sufficient.
NOTE 3 In the case of highly polluted waste water, especially if containing a high amount
of surfactants, a loss in recovery may occur.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 9377-2:2000
ДействующийWater quality — Determination of hydrocarbon oil index — Part 2: Method using solvent extraction and gas chro…
Overview ISO 9377-2:2000 specifies a laboratory method for determining the hydrocarbon oil index in water by solvent extraction and gas chromatography (GC‑FID). Applicable to surface water, waste wat…
ISO/TR 11046:1994
ОтменёнSoil quality — Determination of mineral oil content — Method by infrared spectrometry and gas chromatographic…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…