BS ISO 10952:2014
Plastics piping systems. Glass-reinforced thermosetting plastics (GRP) pipes and fittings. Determination of the resistance to chemical attack for the inside of a section in a deflected condition
Plastics piping systems. Glass-reinforced thermosetting plastics (GRP) pipes and fittings. Determination of the resistance to chemical attack for the inside of a section in a deflected condition
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 30 апреля 2014 г.
- ICS:
- 23.040.20
- SKU:
- BS ISO 10952:2014
Abstract
1 Scope This International Standard specifies a method for determining the chemical resistance properties of glass-reinforced thermosetting plastics (GRP) pipes and fittings in a deflected condition for nominal sizes DN 100 and larger. In conjunction with ISO 10928, this International Standard provides a method for evaluating the effect of a chemical environment on the interior of a pipe or fitting after a specified period of time. Test conditions and requirements are specified in the referring International Standard. ISO 10467 references this International Standard.
NOTE It has been found that the effect of chemical environments can be accelerated by strain induced from deflection; hence, it is frequently referred to as strain corrosion.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 10928:2024
ДействующийPlastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Methods for regr…
Overview ISO 10928:2024 - Plastics piping systems - Glass‑reinforced thermosetting plastics (GRP) pipes and fittings - Methods for regression analysis and their use - defines statistical procedures f…
ISO 10467:2018
ОтменёнPlastics piping systems for pressure and non-pressure drainage and sewerage — Glass-reinforced thermosetting…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…