BS ISO 11228-3:2007
Ergonomics. Manual handling - Handling of low loads at high frequency
Ergonomics. Manual handling - Handling of low loads at high frequency
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 30 апреля 2007 г.
- ICS:
- 13.180
- SKU:
- BS ISO 11228-3:2007
Abstract
1 Scope This part of ISO 11228 establishes ergonomic recommendations for repetitive work tasks involving the manual handling of low loads at high frequency. It provides guidance on the identification and assessment of risk factors commonly associated with handling low loads at high frequency, thereby allowing evaluation of the related health risks to the working population. The recommendations apply to the adult working population and are intended to give reasonable protection for nearly all healthy adults. Those recommendations concerning health risks and control measures are mainly based on experimental studies regarding musculoskeletal loading, discomfort/pain and endurance/fatigue related to methods of working. For the evaluation of working postures, refer to ISO 11226. This part of ISO 11228 is intended to provide information for all those involved in the design or redesign of work, jobs and products.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 11228-2:2007
ДействующийErgonomics — Manual handling — Part 2: Pushing and pulling
Overview ISO 11228-2:2007 - Ergonomics: Manual handling - Part 2: Pushing and pulling provides recommended limits and practical guidance for whole-body pushing and pulling tasks. The standard helps a…
ISO 11226:2000
ДействующийErgonomics — Evaluation of static working postures
Overview ISO 11226:2000 - Ergonomics - Evaluation of static working postures provides internationally recognized guidance for assessing and limiting the health risks associated with static working po…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…