BS ISO 14743:2004
Pneumatic fluid power. Push-in connectors for thermoplastic tubes
Pneumatic fluid power. Push-in connectors for thermoplastic tubes
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 8 декабря 2004 г.
- ICS:
- 23.100.40
- SKU:
- BS ISO 14743:2004
Abstract
1 Scope This International Standard specifies the general requirements and test methods for the design and performance of push-in connectors for use with thermoplastic tubes with outside diameters of 3 mm to 12 mm, inclusive. This International Standard is intended to establish uniform methods of testing complete push-in connector assemblies as used in pneumatic fluid power applications. It is not applicable to air braking systems.
NOTE In road vehicles, it is necessary to exercise special care to ensure that these connectors are never used in an air braking system.
Похожие стандарты
Другие стандарты BS
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…