BS ISO 3548-1:2014
Plain bearings. Thin-walled half bearings with or without flange - Tolerances, design features and methods of test
Plain bearings. Thin-walled half bearings with or without flange - Tolerances, design features and methods of test
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 30 июня 2014 г.
- ICS:
- 21.100.10
- SKU:
- BS ISO 3548-1:2014
Abstract
1 Scope This part of ISO 3548 specifies tolerances, design features, and test methods for thin-walled half bearings with integral flange up to an outside diameter of D o = 250 mm and without flange up to an outside diameter of D o = 500 mm. Due to the variety of design, it is, however, not possible to standardize the dimensions of the half bearings. Half bearings according to this part of ISO 3548 are predominantly used in reciprocating machinery and consist of a steel backing and one or more bearing metal layers on the inside. In reciprocating machinery, flanged half bearings can be used in connection with half bearings without flange. Alternatively, to serve as a flanged half bearing, it is possible to use a half bearing without flange together with two separate half thrust washers according to ISO 6526; or a half bearing with assembled flanges.
NOTE All dimensions and tolerances are given in millimetres.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
BS ISO 3548-2:2020
ДействующийPlain bearings. Thin-walled half bearings with or without flange. Measurement of wall thickness and flange th…
ISO 6526:2017
ДействующийPlain bearings — Pressed bimetallic half thrust washers — Features and tolerances
Overview ISO 6526:2017 specifies the features and tolerances for pressed bimetallic half thrust washers (plain bearings) with an outside diameter up to 160 mm. All linear dimensions and tolerances ar…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…