BS ISO 5350-4:2006
Pulps. Estimation of dirt and shives - Instrumental inspection by reflected light using equivalent black area (EBA) method
Pulps. Estimation of dirt and shives - Instrumental inspection by reflected light using equivalent black area (EBA) method
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Дата публикации:
- 31 октября 2006 г.
- ICS:
- 85.040
- SKU:
- BS ISO 5350-4:2006
Abstract
1 Scope This part of ISO 5350 specifies a method using instrumental inspection by reflected light for the estimation of visible dirt and shives in pulp manufactured in sheets , in terms of Equivalent Black Area (EBA) of dirt specks within the physical area range of 0,02 mm 2 to 3,0 mm 2 . Using the algorithm prescribed in this part of ISO 5350, the maximum dirt size is limited to 3,0 mm 2 . Extension to other speck sizes (for example, those greater than 3,0 mm 2 in physical area) may require changes in equipment, calculation procedures, or both, and is not covered in this part of ISO 5350. This part of ISO 5350 cannot be used for physical area measurements, since it may not correctly measure the dirt specks for that mode of measurement. The specimen to be evaluated should have a brightness, as determined by ISO 3688, of 30 % or greater. It may be necessary to reform some pulp sheets into laboratory sheets , if the surface is too rough or textured. This part of ISO 5350 is also intended for recycled pulp.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 5350-2:2006
ДействующийPulps — Estimation of dirt and shives — Part 2: Inspection of mill sheeted pulp by transmitted light
Overview ISO 5350-2:2006 - "Pulps - Estimation of dirt and shives - Part 2: Inspection of mill sheeted pulp by transmitted light" defines a visual method to estimate visible dirt and shives in mill-s…
BS ISO 3688:2022
ДействующийPulps. Preparation of laboratory sheets for the measurement of optical properties.
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…