BS ISO 6162-1:2012
Hydraulic fluid power. Flange connections with split or one-piece flange clamps and metric or inch screws - Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 127
Hydraulic fluid power. Flange connections with split or one-piece flange clamps and metric or inch screws - Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 127
- Статус документа:
- D
- Формат:
- Электронный (PDF)
- Дата публикации:
- 31 декабря 2012 г.
- ICS:
- 23.100.40
- SKU:
- BS ISO 6162-1:2012
Abstract
1 Scope This part of ISO 6162 gives general and dimensional specifications for flanged heads, split flange clamps (FCS and FCSM), one-piece flange clamps (FC and FCM), ports and mounting surfaces applicable to four-screw, split and one-piece flange clamp type tube connectors and hose fittings for use at pressures of 3,5 MPa (35 bar 1) ) to 35 MPa (350 bar). It also specifies the dimensions of the seals to be used, as well as the grooves that house the seals. This part of ISO 6162 also recognizes the need to accommodate metric screw fasteners (type 1), as well as to provide a means to use existing inch screw fasteners (type 2). These connections are intended for application in hydraulic systems on industrial and commercial products where it is desired to avoid the use of threaded connectors. Surges of pressure higher than the nominal ratings can reduce the ability of the flange connections to retain the hydraulic fluid. This needs to be taken into account in the design of the hydraulic system.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 616:2021
ДействующийCoke — Determination of shatter indices
Overview ISO 616:2021 - "Coke - Determination of shatter indices" specifies a standardized laboratory method to determine the mechanical strength of coke using the shatter test. The shatter index is…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…