BS ISO 6721-8:2019
Plastics. Determination of dynamic mechanical properties - Longitudinal and shear vibration. Wave-propagation method
Plastics. Determination of dynamic mechanical properties - Longitudinal and shear vibration. Wave-propagation method
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Дата публикации:
- 30 апреля 2019 г.
- ICS:
- 83.080.01
- SKU:
- BS ISO 6721-8:2019
Abstract
What is ISO 6721-8 - Longitudinal and shear vibration of plastic about?
ISO 6721-8 is the eighth part of the ISO 6721 multi-series on dynamic mechanical properties of plastic. ISO 6721-8 describes an ultrasonic wave propagation method for determining the storage components of the longitudinal complex modulus L * and the shear complex modulus G * of polymers at discrete frequencies typically in the range 0,5 MHz to 5 MHz the method is suitable for measuring materials with storage moduli in the range 0,01 GPa to 200 GPa and with loss factors below 0,1 at around 1 MHz. With materials that have a higher loss, significant errors in velocity measurement are introduced through waveform distortion and can only be reduced using procedures that are outside the scope of ISO 6721-8.
Note: The method allows measurements to be made on small specimens, typically 50 mm × 20 mm × 5 mm, or small regions of larger specimens or sheets. It is therefore possible to obtain information on the homogeneity or anisotropy of modulus in a specimen.
Who is ISO 6721-8 - Longitudinal and shear vibration of plastic for <strong data-...
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 6721-8:2019
ДействующийPlastics — Determination of dynamic mechanical properties — Part 8: Longitudinal and shear vibration — Wave-p…
Overview ISO 6721-8:2019 - "Plastics - Determination of dynamic mechanical properties - Part 8: Longitudinal and shear vibration - Wave‑propagation method" specifies an ultrasonic wave propagation me…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…