BS ISO 7902-1:2020
Hydrodynamic plain journal bearings under steady-state conditions. Circular cylindrical bearings - Calculation procedure
Hydrodynamic plain journal bearings under steady-state conditions. Circular cylindrical bearings - Calculation procedure
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 31 июля 2020 г.
- ICS:
- 21.100.10
- SKU:
- BS ISO 7902-1:2020
Abstract
What is ISO 7902 ‑ 1 standard about?
ISO 7902 ‑ 1 is the first part of a series of documents on cylindrical bearings. ISO 7902 ‑ 1 specifies a calculation procedure for oil-lubricated hydrodynamic plain bearings, with complete separation of the shaft and bearing sliding surfaces by a film of lubricant, used for designing plain bearings that are reliable in operation.
ISO 7902 ‑ 1 deals with circular cylindrical bearings having angular spans, Ω, of 360°, 180°, 150°, 120°, and 90°, the arc segment being loaded centrally. Their clearance geometry is constant except for negligible deformations resulting from lubricant film pressure and temperature.
The calculation procedure serves to provide dimensions and optimize plain bearings in turbines, generators, electric motors, gear units, rolling mills, pumps, and other machines. It is limited to steady-state operation, i.e. under continuously driven operating conditions, with the magnitude and direction of loading as well as the angular speeds of all rotating par...
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 7902-2:2020
ДействующийHydrodynamic plain journal bearings under steady-state conditions — Circular cylindrical bearings — Part 2: F…
Overview ISO 7902-2:2020 is Part 2 of the ISO 7902 series for hydrodynamic plain journal bearings. It specifies the numerical values of the basic functions used in the calculation procedure for oil‑l…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…