IEC 61857-21:2009

Overview

IEC 61857-21:2009 specifies procedures for the thermal evaluation of electrical insulation systems (EIS), focusing on general-purpose models (GPM) and a tall channel alternative model (GPM-TC) for wire-wound applications. Published by the International Electrotechnical Commission (IEC), this third edition ensures compatibility with IEC 61857-1 and IEC 61857-22, providing clear requirements for evaluating EIS in cases where specific electrotechnical products are not available or needed.

This international standard is critical for quality assurance, product reliability, and safety in electrical engineering, especially in the development and qualification of insulation systems for motors, transformers, and similar electrical equipment with wire-wound components.

Key Topics

• General-Purpose Models (GPM and GPM-TC):

  • Defined models for representing wire-wound electrical insulation systems.
  • GPM: Two-coil configuration; GPM-TC: Three-coil, tall channel setup for broader assessment.
  • Both models allow for the evaluation of earth (ground) insulation and coil-to-coil insulation.

• Test Procedures and Criteria:

  • Step-by-step procedures for model construction, component assembly, and test object preparation.
  • Thermal endurance cycles including thermal ageing, mechanical stress, thermal shock, moisture exposure, and dielectric diagnostic testing.
  • Minimum of ten test objects per group and temperature.

• Screening and Endurance Testing:

  • Initial screening through visual inspections, dielectric tests, mechanical stress, and environmental exposures.
  • Diagnostic tests after each cycle to identify insulation failure or degradation.

• End-of-Life Criteria:

  • Clearly defined conditions under which a specimen is considered to have failed, ensuring consistent evaluation across different EIS candidates.

• Reporting and Classification:

  • Requirements for data analysis, reporting results, and classifying evaluated electrical insulation systems according to IEC 61857-1 guidance.

Applications

• Qualification of Electrical Insulation Systems:
  Suitable for manufacturers and laboratories seeking standardized methods to assess the thermal and electrical reliability of insulation systems in wire-wound hardware.

• Product Development and Testing:
  Enables designers and engineers to simulate and test EIS under controlled, repeatable conditions without access to specific end-use products.

• Regulatory Compliance:
  Supports certification and verification that insulation systems meet industry and safety standards, a necessity for commercial and industrial electrical equipment.

• Quality Assurance:
  Provides a structured approach for ongoing verification of insulation system performance, especially during changes in materials or suppliers.

Related Standards

• IEC 61857-1:
  Outlines general requirements and procedures for the thermal evaluation of low-voltage electrical insulation systems.

• IEC 61857-22:
  Covers requirements for polyester and polyimide-based insulation models as an alternative to general-purpose models.

• IEC 60505:
  Specifies the evaluation and qualification processes for electrical insulation systems more broadly.

• IEC 60464 (all parts):
  Standards for electrical insulation varnishes.

• IEC 60455 (all parts):
  Related to resin-based reactive compounds for electrical insulation.

• IEC 60050-195:
  International Electrotechnical Vocabulary for earthing and protection against electric shock.

Conclusion

IEC 61857-21:2009 delivers a reliable, standardized procedure for the thermal evaluation of electrical insulation systems in wire-wound applications when specific product samples are unnecessary or unavailable. Its detailed modeling and test protocols facilitate improved insulation system design, enhance product safety, and streamline approval processes in the electrical engineering sector. By following these requirements, organizations can ensure the durability, reliability, and compliance of their electrical insulation solutions.