ISO 11673:2005

Overview

ISO 11673:2005 - Unplasticized poly(vinyl chloride) (PVC-U) pressure pipes - Determination of the fracture toughness properties - specifies a laboratory test method to determine the minimum fracture toughness of PVC‑U pressure pipes. The method locates the pipe circumference region most susceptible to solvent attack (using dichloromethane), extracts a C‑ring test piece from that location, introduces a controlled notch and subjects the C‑ring to a sustained flexural stress to measure fracture behavior after a specified loading time. The standard also provides procedures for measuring alternative fracture toughness levels.

Key topics and technical requirements

• Preliminary dichloromethane (DCM) immersion test to identify the point of minimum gelation/maximum attack around the pipe circumference (tests at 15 °C or 20 °C with defined immersion times).
• Use of a C‑ring (ring section ≈ 30 ± 3 mm wide) cut perpendicular to the pipe axis for fracture testing.
• Notch preparation requirements: included angle ~45° (±2°), notch-tip radius ≤ 0.025 mm, uniform notch depth and tight thickness tolerances.
• Test apparatus and setup: rigid support clamps matching pipe radius, loading device to apply and maintain a controlled bending moment, timing accuracy and mass measurement requirements.
• Measurement and expression of results in terms of stress intensity factor (K), critical stress intensity factor (Kc) and plain-strain fracture toughness (KIC) where applicable. The standard references the geometric correction factor, yield stress and notch depth in K calculations.
• Reporting requirements and annexed mathematical calculations, conditioning and yield strength determination guidance.

Practical applications

• Quality control and production acceptance testing for PVC‑U pressure pipes used in water, drainage and fluid transport systems.
• Verification of material resistance to brittle fracture originating from small flaws or localized gelation variations.
• Design validation and safety assessment where fracture toughness is a requirement in product standards or project specifications.
• Failure analysis and materials comparison during R&D or when selecting PVC‑U formulations and processing conditions.

Who should use this standard

• Pipe manufacturers and materials engineers developing or qualifying PVC‑U pressure pipe products.
• Independent testing laboratories performing mechanical and fracture toughness testing.
• Product standards committees, specifiers and regulatory bodies that reference fracture toughness criteria for compliance.
• Quality assurance teams responsible for batch testing and certification.

Related standards

• ISO 9852 - PVC‑U pipes - Dichloromethane resistance test (DCMT)
• ISO 6259‑2 - Thermoplastics pipes - Tensile properties - Part 2: PVC‑U and related materials

Keywords: ISO 11673:2005, PVC‑U fracture toughness, C‑ring test, dichloromethane, pressure pipes, stress intensity factor, fracture toughness test.