ISO 22477-1:2018

Overview

ISO 22477-1:2018 - "Geotechnical investigation and testing - Testing of geotechnical structures - Part 1: Testing of piles: static compression load testing" - specifies how to perform static axial compression pile load tests to determine pile load–displacement behaviour. The standard applies to all pile types, including vertical and raking piles, and is limited to maintained (static) load tests (it does not cover constant-penetration-rate or cyclic load tests). It is intended to be used together with EN 1997‑1 for design-related partial factors and correlations.

Key technical topics and requirements

• Scope: Single-pile axial static compression testing to check pile performance or measure resistance.
• Reaction systems: Acceptable reaction devices include dead load (kentledge), tension piles or anchors, or an existing structure. Design must resist the maximum test load and minimize influence on the test pile. Dead loads should be centred and exceed the maximum test load by at least 10%.
• Force input: One or more hydraulic jacks recommended; jacks must be symmetric, fed from a common supply, equipped with shut‑off valves and pressure gauges. Stroke and capacity must exceed expected deformations and maximum test load.
• Accuracy and control: Load regulators should have accuracy better than 0.5% of the maximum test load (Fp) or 10 kN, whichever is greater. Smooth, controllable application and maintenance of load are required.
• Displacement measurement: Pile head displacement measured by at least three transducers or dial gauges, arranged symmetrically and supported from reference beams independent of the test pile. Minimum clear distances for reference beam supports are 2.5 m or 2.5D (whichever greater); micropiles may use reduced distances but not less than 1.5 m.
• Test procedure and reporting: The standard covers test preparation, loading sequences (single and multiple cycle procedures), measuring intervals, and detailed test reporting (general information, data reporting and interpretative report).
• Supplementary material: Informative annexes address topics such as critical creep load and bi-directional load testing.

Practical applications and users

ISO 22477-1 is used to:

• Verify that piles behave as designed (performance checks).
• Measure pile compressive resistance for foundation design and QA/QC.
• Provide test evidence for geotechnical design verification, construction acceptance, and forensic assessment after unusual loading or settlement.

Typical users:

• Geotechnical and structural engineers
• Construction and piling contractors
• Testing laboratories and site testing teams
• Owners, project managers, and quality assurance personnel

Related standards and SEO keywords

• Use with: EN 1997‑1 (Eurocode 7 Part 1) for design factors and interpretation.
• Normative references include ISO 7500‑1 and Eurocodes (EN 1990, EN 1997‑2).
• Relevant keywords: ISO 22477-1, static pile load testing, static compression load testing, pile load tests, geotechnical testing, pile instrumentation, hydraulic jack, reaction device, displacement measurement, maintained load tests.

This standard provides clear execution and reporting rules for reliable static pile load tests used in modern geotechnical design and construction control.