ISO 2330:2002

Overview - ISO 2330:2002 (Fork-lift trucks - Fork arms)

ISO 2330:2002 defines manufacturing, testing and marking requirements for solid-section fork arms used on fork-lift trucks. It applies to fork arms produced in quantity and covers common mounting types (hook-on, shaft/pin, bolt-on, roller, etc.). The standard sets mandatory tests for prototypes and provisions for periodic testing in production to ensure structural performance, toughness and fatigue resistance.

Key topics and technical requirements

• Scope and materials
  • Applies to solid-section fork arms; may be applied to non-quantity manufacture by agreement.
• Prototype and production testing
  • Yield test: Load applied twice (gradually, without shock), held 30 s - no permanent deflection allowed between readings. Test load for capacities up to 5 500 kg is three times the specified capacity; higher-capacity arms use a reduced safety factor (minimum specified).
  • Impact test: Charpy V-notch specimens per ISO 148 at −20 °C; minimum energy requirement is 27 J.
  • Fatigue (dynamic) test: Required for prototypes at or below specified capacity/load-centre limits. Dynamic peak load typically 1.25 × specified capacity (minimum 0.1 × capacity). Test frequency limited to ≤ 10 Hz, reduce if fork temperature exceeds 50 °C or resonance occurs. No cracks or permanent deformation allowed after the test.
• Surface-crack detection
  • Visual inspection plus a non‑destructive testing (NDT) method; magnetic particle inspection is recommended, with special attention to heels, welds and heat-affected zones.
• Marking
  • Each fork arm must be permanently marked with: specified capacity (kg), load centre (mm), manufacturer ID, and date or serial number. Truck manufacturer info may be added by request.
• Normative references
  • Important referenced standards include ISO 148, ISO 2328, ISO 2331 and ISO 683‑1.

Applications and who uses this standard

• Fork arm and fork-lift truck manufacturers - design validation, production control, and compliance.
• Quality, test and R&D laboratories - performing yield, impact, fatigue and NDT per standard requirements.
• Procurement and OEMs - specifying conforming fork arms and verifying supplier compliance.
• Safety managers and maintenance teams - ensuring replacement forks meet marked capacity and inspection criteria.

Related standards

• ISO 148 - Charpy impact test
• ISO 2328 - Hook-on fork arm mounting dimensions
• ISO 2331 - Fork arm vocabulary
• ISO 683‑1 - Heat‑treatable steels (materials guidance)

Using ISO 2330:2002 helps ensure reliable fork arm performance, consistent marking for safe operation, and traceable testing procedures for regulatory and commercial acceptance.