ISO 6836:1983
Surface active agents — Mercerizing agents — Evaluation of the activity of wetting products for mercerization by determination of the shrinkage rate of cotton
Surface active agents — Mercerizing agents — Evaluation of the activity of wetting products for mercerization by determination of the shrinkage rate of cotton
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Количество страниц:
- 5
- Дата публикации:
- 1 февраля 1983 г.
- Издание:
- ISO IS 6836 edition 1 version 1
- ICS:
- 71.100.40
The test is carried out in the following way: Immersion in the liquor containing the agent being studied of a hank of smooth cotton held by a hook and with a load fixed on the end of it. determination of the shrinkage of the hank at different intervals of time using one of the tow pieces of apparatus described.
Abstract
Overview
ISO 6836:1983 specifies a laboratory method to evaluate the activity of wetting products for mercerization (mercerizing agents) by measuring the shrinkage rate of cotton yarn hanks when exposed to caustic (sodium hydroxide) mercerizing baths. The standard is aimed at testing surface active agents used to improve penetration of mercerizing liquor into cellulose fibres, a key factor that controls effectiveness and processing time in mercerizing operations.
Key topics and requirements
- Scope: Method applies only to mercerizing/causticizing baths and wetting products used in those baths.
- Test principle: Immerse a prepared hank of smooth cotton with a fixed weight attached, then record longitudinal shrinkage at timed intervals; the speed and extent of shrinkage indicate wetting effectiveness.
- Sample preparation:
- Test hank: wind on a 1 m perimeter winder to obtain a hank mass of 1 ± 0.2 g, fold to approximately 24 cm.
- Conditioning: store hanks for at least 24 h at 20 ± 2 °C and 65% ± 2% RH before testing.
- Reagents and solution:
- Mercerizing liquor: sodium hydroxide solution prepared as described in the standard (example: dissolve 270 g NaOH in 1 litre water as given).
- Use analytical-grade reagents and distilled or equivalent water.
- Apparatus:
- Two accepted measuring setups: Hintzmann apparatus (millimetre scale and weight) or a servo apparatus (graduated disc with moving needle).
- Typical weights mentioned: a small weight 10 ± 0.1 g and a counterweight about 50 g (selection depends on yarn type and must be reported).
- Test procedure and data:
- Prepare solution immediately before testing (first solution used within 15 minutes).
- Measure shrinkage at 10 s intervals up to 90 s, and finally at 300 s (5 min); perform five series and use arithmetic means.
- Results expressed as rate of shrinkage (mm/time), percentage shrinkage, and time to reach 50% of total shrinkage (determined via plotting/logarithmic scale).
Applications and users
- Textile testing and quality control laboratories assessing mercerizing wetting agents.
- Chemical manufacturers of surfactants and mercerizing auxiliaries evaluating product performance.
- Textile mills optimizing mercerizing process parameters to reduce cycle time and improve fabric uniformity.
- Standards organizations and R&D groups comparing wetting efficiency across formulations or yarn batches.
Related standards
- ISO 607 (sample division for surface active agents and detergents) is referenced within ISO 6836:1983.
- Developed by ISO/TC 91 (Surface active agents).
Keywords: ISO 6836:1983, mercerizing agents, surface active agents, wetting products, shrinkage rate, cotton, mercerization testing, Hintzmann apparatus, servo apparatus, sodium hydroxide solution.
Технические детали
- Технический комитет
- ISO/TC 91 - Surface active agents
- SKU
- ISO 6836:1983
Похожие стандарты
Упомянутые в описании и другие стандарты ISO
ISO 6078:1982
ДействующийBlack tea — Vocabulary
Overview ISO 6078:1982 - Black tea - Vocabulary is an international standard published by ISO (first edition 1982) that provides a bilingual (English/French) glossary of terms used in the commercial…
ISO 8212:1986
ОтменёнSoaps and detergents — Techniques of sampling during manufacture
Overview Standard Reference: ISO 8212:1986 Title: Soaps and detergents - Techniques of sampling during manufacture ISO 8212:1986 defines standardized techniques for taking representative samples of s…
ISO 20662:2020
ДействующийShips and marine technology — Hopper dredger supervisory and control systems
Overview ISO 20662:2020 - Ships and marine technology: Hopper dredger supervisory and control systems (HD‑SCS) - specifies the components, structure, general requirements, and functional requirements…
ISO 3021:2023
ДействующийAdventure tourism — Hiking and trekking activities — Requirements and recommendations
Overview ISO 3021:2023 - Adventure tourism: Hiking and trekking activities - Requirements and recommendations defines safety-focused requirements and recommendations for hiking and trekking offered a…
ISO 3826-2:2008
ДействующийPlastics collapsible containers for human blood and blood components — Part 2: Graphical symbols for use on l…
Overview ISO 3826-2:2008 - "Plastics collapsible containers for human blood and blood components - Part 2: Graphical symbols for use on labels and instruction leaflets" defines a system of internatio…
ISO/IEC 24730-1:2014
ДействующийInformation technology — Real-time locating systems (RTLS) — Part 1: Application programming interface (API)
Overview ISO/IEC 24730-1:2014 specifies the Application Programming Interface (API) for Real‑Time Locating Systems (RTLS). The standard defines a minimal, interoperable boundary that lets application…
ISO 8668-5:1992
ДействующийAircraft — Terminal junction systems — Part 5: Detail specification for type 3 system
Overview - ISO 8668-5:1992 (Aircraft terminal junction systems, Type 3) ISO 8668-5:1992 defines the detail specification for Type 3 Terminal Junction Systems (TJS) used in aircraft electrical install…
ISO 7574-3:1985
ДействующийAcoustics — Statistical methods for determining and verifying stated noise emission values of machinery and e…
Overview ISO 7574-3:1985 is part of the ISO 7574 series on acoustics and provides a simple (transition) statistical method for determining and verifying stated noise emission values for batches (lots…