ASTM F3378/F3378M-22

SCOPE 1.1 This specification covers outside diameter controlled crosslinkable polyethylene (CX-PE) pipe produced in sizes DN 25 to 630 and NPS 1 to 24 in various dimension ratios. Included in this specification are requirements and test methods for the determination of the long-term hydrostatic strength, hydrostatic burst pressure, hydrostatic sustained pressure, UV weathering resistance, initial and ultimate degree of crosslinking, workmanship, and marking. 1.2 This specification shall not be applied to crosslinked products, specifically PEX pipe or tubing. Note 1: CX-PE is a different designation separate from conventional PEX materials, specifically with regard to the crosslinking rate, installation, and commissioning processes. 1.3 The pipe covered by this specification is intended for pressure and non-pressure applications. Fluids such as non-potable water, multi-phase mixed fluids, crude oils, gases, and chemical solutions containing some water are allowed to be transported in pipe made in accordance with this standard. Permissible operating temperatures for commissioned piping systems constructed from CX-PE pipe manufactured in accordance with this specification are ≤ 200 °F [93 °C]. 1.4 Pipe produced in accordance with this specification is intended to be crosslinked during or after installation. The procedures and practices to be used for the installation and crosslinking of the CX-PE pipe are outside the scope of this specification. Manufacturer’s recommendations for the commissioning of CX-PE pipe are used to ensure that the performance of the completed piping system meets design expectations. Note 2: The difference between pipes made in accordance with this specification and PEX pipes made in accordance with Specification F2905 is that the final crosslinking process is completed as part of installation and commissioning as opposed to crosslinking taking place in the manufacturing facility. 1.5 This specification includes requirements to demonstrate a minimum level of performance in service. 1.6 Joining of CX-PE pipes made in accordance with this specification is outside the scope of this specification. For guidance on the joining of CX-PE pipe consult Practice F3507 and manufacturer’s recommendations. 1.7 This specification references notes, footnotes, and appendixes, which provide non-mandatory explanatory material. Excluding table footnotes which are mandatory, notes, footnotes and information in parentheses shall not be considered as requirements of this specification. 1.8 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.10 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.