BS EN IEC 62057-1:2023
Electrical energy meters. Test equipment, techniques and procedures - Stationary meter test units (MTUs)
Electrical energy meters. Test equipment, techniques and procedures - Stationary meter test units (MTUs)
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Дата публикации:
- 31 мая 2023 г.
- ICS:
- 17.220.01
- Технический комитет:
- CENELEC
- SKU:
- BS EN IEC 62057-1:2023
Abstract
1 Scope This part of IEC 62057 applies to stationary meter test units (MTUs) permanently installed in laboratories, used for testing and calibration of electricity meters, in particular for their type test, acceptance test and verification test. It covers the requirements for automatic MTUs for indoor laboratory application and applies to newly manufactured MTUs to test electricity meters on 50 Hz or 60 Hz networks with an AC voltage up to 600 V (phase to neutral). If meters are intended for system voltages not specified in this document, special requirements are agreed between the manufacturer and the purchaser. This document also defines the kind of tests to perform as type tests / routine tests / acceptance tests and commissioning tests for MTUs. It does not apply to:
portable reference meters and portable sources; electricity meters; data interfaces to the meter and test procedures of data interface; transformer operated MTUs; personal computers supplied together with the MTU.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
IEC 62057-1:2023
ДействующийElectrical energy meters - Test equipment, techniques and procedures - Part 1: Stationary meter test units (M…
Overview IEC 62057-1:2023 is an international standard published by the International Electrotechnical Commission (IEC) that specifies requirements for stationary meter test units (MTUs) used in labo…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…