BS ISO 26842-1:2013
Adhesives. Test methods for the evaluation and selection of adhesives for indoor wood products - Resistance to delamination in non-severe environments
Adhesives. Test methods for the evaluation and selection of adhesives for indoor wood products - Resistance to delamination in non-severe environments
- Статус документа:
- Отменён
- Формат:
- Электронный (PDF)
- Дата публикации:
- 30 июня 2013 г.
- ICS:
- 83.180
- SKU:
- BS ISO 26842-1:2013
Abstract
1 Scope This part of ISO 26842 gives guidelines to select, by means of delamination-resistance tests, adhesive/wood combinations in non-severe environments, in which the products are not exposed to extreme changes in temperature and humidity. A series of exposure cycles at various temperature and humidity values is provided to verify that the adhesive selected, or a product bonded with the adhesive, meets the necessary requirements for resistance to delamination. This part of ISO 26842 is intended to help the user not only to select a suitable adhesive, but also to evaluate adhesives and adhesively bonded wood products.
NOTE When actual wood products are tested using this method, the test results might not be comparable because the test laboratory will not normally have had adequate control over the way the product was assembled.
This part of ISO 26842 is not intended for use in the qualification of structural components.
Похожие стандарты
Упомянутые в описании и другие стандарты BS
ISO 26842-2:2020
ДействующийAdhesives — Test methods for the evaluation and selection of adhesives for indoor wood products — Part 2: Res…
Overview ISO 26842-2:2020 sets out test methods and selection guidelines for adhesives used in indoor wood products that must resist delamination in severe environments (extreme temperature and humid…
BS ISO 10835:2007
ДействующийDirect reduced iron and hot briquetted iron. Sampling and sample preparation.
1 Scope This International Standard gives a) the underlying theory, b) the basic principles for sampling and preparation of samples , and c) the basic requirements for the design, installation and op…