ISO 15970:2008
Natural gas — Measurement of properties — Volumetric properties: density, pressure, temperature and compression factor
Natural gas — Measurement of properties — Volumetric properties: density, pressure, temperature and compression factor
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Количество страниц:
- 47
- Дата публикации:
- 9 июня 2008 г.
- Издание:
- ISO IS 15970 edition 1 version 1
- ICS:
- 75.060
ISO 15970:2008 gives requirements and procedures for the measurement of the properties of natural gas that are used mainly for volume calculation and volume conversion: density at reference and at operating conditions, pressure, temperature and compression factor. Only those methods and instruments are considered that are suitable for field operation under the conditions of natural gas transmission and distribution, installed either in-line or on-line, and that do not involve the determination of the gas composition. ISO 15970:2008 gives examples for currently used instruments that are available commercially and of interest to the natural gas industry. The density at reference conditions (sometimes referred to as normal, standard or even base density) is required for conversion of volume data and can be used for other physical properties. Density at operating conditions is measured for mass-flow measurement and volume conversion using the observed line density and can be used for other physical properties. ISO 15970:2008 covers density transducers based on vibrating elements, normally suitable for measuring ranges of 5 kg/m3 to 250 kg/m3. Pressure measurement deals with differential, gauge and absolute pressure transmitters. It considers both analogue and smart transmitters (i.e. microprocessor based instruments) and, if not specified otherwise, the corresponding paragraphs refer to differential, absolute and gauge pressure transmitters without distinction. Temperature measurements in natural gas are performed within the range of conditions under which transmission and distribution are normally carried out (253 K T The compression factor (also known as the compressibility factor or the real gas factor and given the symbol Z) appears, in particular, in equations governing volumetric metering. Moreover, the conversion of volume at metering conditions to volume at defined reference conditions can properly proceed with an accurate knowledge of Z at both relevant pressure and relevant temperature conditions.
Abstract
Overview
ISO 15970:2008 - Natural gas - Measurement of properties - Volumetric properties: density, pressure, temperature and compression factor - specifies requirements and field procedures for measuring the volumetric properties of natural gas used mainly for volume calculation and conversion. The standard covers density at reference and operating conditions, pressure (differential, gauge, absolute), temperature and the compression factor (Z). It focuses on instruments and methods suitable for in-line or on-line field operation in transmission and distribution systems and on techniques that do not require gas composition analysis.
Key Topics and Requirements
- Density measurement
- Defines density at reference (standard/base) and operating conditions for volume conversion and mass-flow calculations.
- Covers density transducers based on vibrating elements, typically for ranges ~5 kg/m3 to 250 kg/m3.
- Includes guidance on installation, sampling, calibration, verification, maintenance and quality control.
- Pressure measurement
- Addresses differential, gauge and absolute pressure transmitters, both analogue and smart (microprocessor-based).
- Sets requirements for performance assessment, installation and calibration.
- Temperature measurement
- Focuses on conditions typical for transmission and distribution (253 K
Технические детали
- Технический комитет
- ISO/TC 193 - Natural gas
- SKU
- ISO 15970:2008
Похожие стандарты
Другие стандарты ISO