ISO 5673-1:2005

Overview

ISO 5673-1:2005 - "Agricultural tractors and machinery - Power take-off drive shafts and power‑input connection - Part 1: General manufacturing and safety requirements" defines manufacturing and safety requirements for PTO drive shafts and the power‑input connection (PIC) used on tractors and self‑propelled agricultural machines. The standard establishes methods to determine PTO static and dynamic torsional strength, sets requirements for guards, lubrication access, spline and thrust characteristics, and specifies what must appear in manufacturer technical documentation. It applies only to PTO drive shafts and guards mechanically linked to the shaft by at least two bearings and does not cover PTO guards by location, environmental aspects, or retroactive equipment manufactured before publication.

Key topics and technical requirements

• Scope & definitions: Terms such as primary/secondary PTO drive shaft, PIC/SPIC, closed/extended length, universal joints, overrun devices and torque limiters are defined for consistent design and testing.
• Torsional strength testing:
  • Method to determine maximum static torsional load for joints and telescopic members (failure criteria defined by change in torque‑deflection or angular permanent deformation).
  • Maximum dynamic torsional load: components must achieve the minimum life declared by the manufacturer under constant torque and angle; journal cross assembly failure rate < 10% (temperature > +120 °C is considered a failure).
• Manufacturing requirements:
  • Spline dimensions for PTO/PIC yokes in accordance with ISO 500‑3.
  • Phasing provisions for telescopic members to ensure correct universal‑joint alignment.
  • Lubrication access and lubrication hole maximum dimension (≤ 30 mm) to allow maintenance without compromising guard integrity.
  • Locking devices on yokes to prevent axial displacement and resist specified thrust forces (example thrust forces: approx. ±9 kN for