ISO 885:2000

Hard coal -- Froth flotation testing -- Part 2: Sequential evaluation

Overview SIST ISO 8858-2:2005 establishes a standardized laboratory procedure for the froth flotation testing of fine hard coal, specifically for coal particles smaller than 0.5 mm. Developed by the…

18 · PDF

32 400 ₽

ISO 8689-1:2000

Water quality — Biological classification of rivers — Part 1: Guidance on the interpretation of biological qu…

Overview ISO 8689-1:2000, titled Water quality - Biological classification of rivers - Part 1: Guidance on the interpretation of biological quality data from surveys of benthic macroinvertebrates, is…

6 · PDF

10 800 ₽

ISO/ASTM51540-04(2012)

Отменён

Standard Practice for Use of a Radiochromic Liquid Dosimetry System (Withdrawn 2020)

Significance and Use4.1 The radiochromic liquid dosimetry system provides a means of measuring absorbed dose in materials (5-7). Under the influence of ionizing radiation, chemical reactions take pla…

ISO/ASTM51204-04

Standard Practice for Dosimetry in Gamma Irradiation Facilities for Food Processing (Withdrawn 2013)

Significance and Use4.1 Food products may be treated with ionizing radiation, such as gamma-rays from 60Co or 137Cs sources, for numerous purposes, including control of parasites and pathogenic micro…

ISO/ASTM51431-05

Отменён

Standard Practice for Dosimetry in Electron Beam and X-Ray (Bremsstrahlung) Irradiation Facilities for Food P…

Significance and Use4.1 Food products may be treated with acceleratorgenerated radiation (electrons and X-rays) for numerous purposes, including control of parasites and pathogenic microorganisms, in…

ISO/ASTM52628-20e1

Standard Practice for Dosimetry in Radiation Processing

1.1 This practice describes the basic requirements that apply when making absorbed dose measurements in accordance with the ASTM E61 series of dosimetry standards. In addition, it provides guidance o…

13 · PDF

23 400 ₽

ISO/ASTM52921-13(2019)

Standard Terminology for Additive Manufacturing—Coordinate Systems and Test Methodologies

Significance and Use 3.1 Although many additive manufacturing systems are based heavily upon the principles of Computer Numerical Control (CNC), the coordinate systems and nomenclature specific to CN…

ISO/ASTMTR52917-EB

Additive Manufacturing — Round Robin Testing — General Guidelines

This document outlines the steps with regard to aspects of design to conduct and run a round robin study (RRS) to assess the degree of variability in an additive manufacturing material or process. Th…