ISO 9285:1997

Standard: ISO 9285:1997 - Abrasive grains and crude - Chemical analysis of fused aluminium oxide

Overview

ISO 9285:1997 specifies standardized chemical analysis methods for abrasive grains and crude materials based on fused aluminium oxide (Al2O3). The standard covers sample preparation, required reagents and apparatus, and detailed procedures for determining loss on ignition and the content of major oxides: silicon dioxide (SiO2), iron oxide (Fe2O3), titanium dioxide (TiO2), calcium oxide (CaO), magnesium oxide (MgO), zirconium oxide (ZrO2) and aluminium oxide (Al2O3). Analytical approaches include gravimetric, colorimetric and atomic absorption spectrometric (AAS) methods. The document also addresses separation steps needed to isolate Fe, Ti, Mg and Ca from aluminium-rich matrices.

Key topics and technical requirements

• Scope and applicability: Applies to commercially available fused-alumina abrasive grains and crude (not necessarily altered-by-use material).
• Sample preparation: Crushing, sieving (2 mm and 150 µm mesh sizes), coning and quartering to obtain representative 10–20 g test portions; precautions to avoid iron contamination (magnetic separation, alternative mortars).
• Loss on ignition: Measured by heating samples in a platinum crucible at 1 100 °C to constant mass.
• Silicon dioxide determination: Two routes - a gravimetric silica separation (fusion, acid treatments, HF step) and a colorimetric molybdosilicate method (spectrophotometric read at 700 nm).
• Separation procedures: Evaporation and controlled alkalinity adjustments to precipitate and separate aluminium from Fe, Ti, Mg and Ca prior to individual determinations.
• Specific determinations: Fe2O3 (colorimetric/gravimetric approaches mentioned), TiO2 (colorimetric), CaO/MgO/ZrO2 (gravimetric), Al2O3 (final determination) and analysis by atomic absorption spectrometry as an alternative for elemental quantification.
• Quality control: Blank determinations and standardized reagents (references to ISO 6353 series) and reporting requirements.

Applications and users

ISO 9285 is designed for:

• Quality control and incoming inspection in abrasives manufacturing and processing plants.
• Analytical laboratories performing certification, material specification compliance and batch release testing for fused aluminium oxide abrasives.
• R&D and failure analysis where impurity levels (SiO2, Fe, Ti, Ca, Mg, Zr) affect abrasive performance, life or bonding behavior.
• Third‑party test houses and standards compliance auditors needing reproducible, internationally recognized chemical analysis methods.

Practical benefits include consistent reporting, improved comparability between labs, and clearer specification limits for abrasive products.

Related standards

• ISO 6353 series - Reagents for chemical analysis
• ISO 9138 - Abrasive grains - Sampling and splitting
• ISO/TC 29 (technical committee) references and Annex A of ISO 9285 for additional methods

Keywords: ISO 9285, fused aluminium oxide, abrasive grains, chemical analysis, silicon dioxide, iron oxide, titanium dioxide, aluminium oxide, atomic absorption spectrometry, loss on ignition, gravimetric, colorimetric.