EN ISO 3953:2025 PDF

Overview

EN ISO 3953:2025 - Metallic powders: Determination of tap density (ISO 3953:2025) specifies a standardized laboratory method to measure the tap density of metallic powders - the bulk density achieved after a powder is mechanically tapped into a calibrated container under defined conditions. Published by ISO and adopted by CEN as EN ISO 3953:2025 (superseding the 2011 edition), this fifth edition includes a precision statement based on an inter‑laboratory study.

Key topics and technical requirements

• Scope: Procedure for determining tap density of metallic powders when tapped into a container under specified apparatus and conditions.
• Apparatus: balance (0.1 g accuracy), graduated glass cylinder (100 cm3 or 25 cm3, specific graduations), and a tapping apparatus with a 3 mm stroke and tapping frequency between 100–300 taps/min (figure example provided).
• Sampling & test portions: Table of required sample masses by apparent density and cylinder capacity (e.g., 100 cm3 or 25 cm3 options) and guidance on testing three test portions where possible.
• Procedure: Clean cylinder, weigh test portion, pour to a level surface, tap until no further volume decrease (practical guidance: determine minimum taps N and typically use 2N for subsequent tests; fine refractory powders may require up to 3 000 taps).
• Measurement & expression of results: Tap density ρt = m / V (g/cm3). Reading resolution specified (±0.5 cm3 for 100 cm3 cylinder, ±0.2 cm3 for 25 cm3) and rounding rules for reported means.
• Precision: Repeatability and reproducibility statistics from a multi‑laboratory study are included for representative powders (water‑atomized iron, gas‑atomized 316L, sub‑micron WC); limits for r and R at 95% confidence are provided.
• Test report: Mandatory items to include (reference to ISO 3953:2025, sample ID, drying procedure if applied, cylinder capacity, sample mass, result, deviations or optional operations, any events affecting results).

Practical applications and users

EN ISO 3953:2025 is used for quality control, material specification and R&D where bulk behavior of metallic powders matters. Typical users include:

• Powder metallurgy producers and laboratories
• Additive manufacturing (metal AM) material qualification teams
• Sintering and pressing process engineers
• Materials testing and accreditation labs
• Purchasing/specification engineers who require standardized density data in supply contracts

Measured tap density supports process control (filling, flow, compaction), powder characterization, batch comparisons, and specification compliance for powder metallurgy and metal additive manufacturing applications.

Related standards

• ISO 5725‑2 (Accuracy - repeatability and reproducibility): cited for the precision study methodology and referenced in the bibliography.