EN ISO 4611:2010 PDF

Overview

EN ISO 4611:2010 (ISO 4611:2010) - titled Plastics - Determination of the effects of exposure to damp heat, water spray and salt mist - defines test conditions and evaluation methods to assess how plastics respond to damp heat, water spray, and salt mist exposures. The standard applies to standard test specimens as well as finished articles or parts, and sets out procedures for observing and measuring changes after specified exposure stages.

Key topics and technical requirements

• Exposure types covered: damp heat (hot, humid atmospheres near saturation), water spray (liquid phase exposure), and salt mist (sodium chloride aerosols representative of marine environments).
• Measured effects:
  • Change in mass (moisture uptake, leaching)
  • Change in dimensions and appearance (swelling, discoloration, surface attack)
  • Change in physical properties (mechanical, electrical or other relevant properties)
• Test principle: determine one or more properties before and after specified exposure periods; results may also be reported after drying or reconditioning to original humidity equilibrium.
• Equipment requirements:
  • Chambers and fixtures must be corrosion resistant and non-contaminating.
  • Sensors for temperature and relative humidity must be located within the chamber working volume.
  • Condensed water must be continuously drained and re-used only if re‑purified; no condensate may fall on specimens.
  • Water used for humidity control must have resistivity ≥ 0.05 MΩ·cm.
  • For water spray and salt mist tests, cabinet volume should be ≥ 0.4 m³ to ensure homogeneous spray distribution.
• Reference methods: aligns results expression with existing methods for chemical exposure and weathering; cites ISO 62 (water absorption).

Applications and who uses it

EN ISO 4611:2010 is used by:

• Materials engineers and polymer R&D for assessing hydrolytic stability and moisture effects.
• Test laboratories and quality control departments performing environmental exposure testing, humidity testing, salt spray testing, and water spray tests.
• Product designers and manufacturers in automotive, marine, electronics, coatings, and outdoor equipment who need data on long-term behaviour in humid, wet or marine environments.
• Compliance and procurement teams specifying performance requirements for components or assemblies that include plastics and metal/plastic interfaces.

Practical uses include screening materials, comparing formulations, verifying protective coatings, and evaluating finished articles containing moulded-in inserts, metal foils, electroplated surfaces, or composite assemblies.

Related standards

• ISO 62 - Plastics - Determination of water absorption
• ISO 175 - Exposure to chemicals (referenced for result expression)
• ISO 4582 - Natural weathering / artificial light exposure (referenced)
• IEC environmental test standards (for electronic components) - complementary guidance

EN ISO 4611:2010 provides standardized, reproducible procedures for assessing the effects of damp heat, water spray and salt mist on plastics, helping stakeholders make informed material and design choices for humid, wet and marine service conditions.