ISO 10890:2010 PDF

Overview

ISO 10890:2010 - "Paints and varnishes - Modelling of biocide release rate from antifouling paints by mass‑balance calculation" specifies a pragmatic, mass‑balance method to estimate the mean biocide release rate from antifouling paints over the specified in‑service lifetime. The method provides a conservative (worst‑case) estimate of total biocide released per unit area and optionally the 14‑day cumulative release, and is intended to support environmental risk assessments and regulatory evaluation of antifouling products.

Key topics and technical requirements

• Scope: Applies to any antifouling paint that releases a biocide; calculations can be repeated for paints releasing multiple biocides. No minimum or maximum release limits restrict use.
• Mass‑balance principle: The total released biocide cannot exceed that originally present in the applied dry film. The estimated mass released per unit area is calculated from:
  • percentage of biocide released over lifetime (default L = 90%),
  • mass fraction of biocide in the biocidal ingredient,
  • content of the biocidal ingredient in the paint (w, % by mass),
  • paint density (ρ) and non‑volatile (volume solids) content (NV),
  • specified dry‑film thickness (DFT) and paint lifetime (t).
• Mean release rate: Mean biocide release rate (µg·cm⁻²·d⁻¹) = estimated mass released per unit area divided by the lifetime (converted to days).
• 14‑day cumulative release: Optional calculation uses an empirical multiplier (default f = 30) to estimate short‑term release behavior typical of many antifouling coatings.
• Reporting: Test report must identify the paint, biocide(s), biocidal ingredient(s), and all parameters used in the calculation (L, a, w, ρ, NV, DFT, t).
• Conservative / correction guidance: Calculated values are typically conservative versus in‑service measurements; the standard recommends applying appropriate correction factors when translating to real‑world environmental loading.

Practical applications

• Environmental risk assessments for antifouling paints and marine coatings.
• Regulatory submissions where a standardized, reproducible release estimate is required.
• Product development and formulation screening to estimate potential biocide loading.
• Estimating worst‑case environmental inputs for modelling marine contamination.
• Use by laboratories, paint manufacturers, shipyards, environmental consultants and regulators to generate comparable, documented release rate estimates.

Who should use this standard

• Paint and biocide manufacturers preparing safety/regulatory dossiers
• Environmental risk assessors and consultants
• Regulatory bodies evaluating antifouling product approvals
• Test laboratories producing standardized release estimates
• Ship operators and naval architects assessing coating selection and environmental impact

Related standards

• ISO 15181 (all parts) - in‑water test methods for antifouling coatings
• ASTM D5108, ASTM D6442, ASTM D6903 - laboratory and field methods referenced for empirical behavior comparisons

Keywords: ISO 10890:2010, biocide release rate, antifouling paints, mass‑balance calculation, environmental risk assessment, 14‑day cumulative release, dry‑film thickness, DFT, volume solids.