ISO 12815:2025 PDF

Overview

ISO 12815:2025 - Fibre-reinforced plastics - Determination of the plain-pin bearing strength - defines a standardized test method to determine the plain-pin bearing strength of fibre‑reinforced plastic (FRP) composites with either thermoset or thermoplastic matrices. The standard specifies specimen geometry, apparatus (including a 6 mm plain pin and loading jig), test procedure, conditioning, data collection and result calculation. The property is reported as the maximum load divided by the projected pin contact area (σp = Pmax / (d × t)) and applies to the specific laminate lay-up tested.

Key topics and requirements

• Scope and principle: Measures plain‑pin bearing strength under tensile loading with a clearance‑fit metallic pin; maximum load defines the property.
• Specimen geometry: Preferred width 36 mm ± 0.5 mm, length 100–180 mm, hole 6 mm diameter (tolerances specified), end distance e typically 36 mm (6 × hole diameter). Alternative sizes must keep specified ratios (width/hole = 6; end distance/hole = 6; pin diameter/specimen thickness = 1.5).
• Apparatus: Test machine per ISO 5893, hardened steel plain pin (6 mm), loading jig with minimum 0.5 mm clearance, accurate load indicator (≤ ±1% full scale).
• Specimen preparation: Panels produced per ISO 1268 series; machining, hole drilling and tabbing guidance included; specimens must be flat and free from damage.
• Test conditions and data: Conditioning per ISO 291; constant test speed (ISO 5893); measure load, failure mode, hole roundness (newly added), and report roundness in test reports.
• Calculation & precision: Defined method to calculate σp and statistical treatment guidance (ISO 2602 referenced).

Practical applications

• Material characterization: quantify bearing resistance of composite laminates for design data.
• Design input for bolted and pinned joints in structural composites (aerospace, automotive, marine, wind energy).
• Quality control and research: compare lay-ups, matrix types (thermoset vs thermoplastic), and processing variations. Note: ISO 12815:2025 measures plain‑pin bearing strength of the laminate, not the full behaviour of a bolted joint under real assembly conditions (torque, washers, relaxation). Additional joint tests (e.g., torqued‑bolt tests) are recommended for specific joint designs.

Who should use it

• Composite materials engineers and test laboratories
• Product designers and structural analysts in aerospace, automotive, marine, wind and sporting goods
• Manufacturers validating laminate lay‑ups and quality control
• Standards bodies and researchers comparing bearing performance across materials

Related standards

• ISO 5893 (test machines), ISO 1268 (test plate manufacture), ISO 527-4 (tensile test conditions), ISO 291 (conditioning), ISO 472, ISO 2602 (statistics).
• Harmonized/related methods: ASTM D5961, prEN 6037 (referenced for alignment and joint testing guidance).

Keywords: ISO 12815:2025, plain-pin bearing strength, fibre-reinforced plastics, FRP bearing test, composite pin bearing, test specimen, pin diameter 6 mm, ISO 5893, ISO 1268.