ISO 13936-2:2004 PDF

Overview

ISO 13936-2:2004 - "Textiles - Determination of the slippage resistance of yarns at a seam in woven fabrics - Part 2: Fixed load method" specifies a laboratory method to measure seam slippage (yarn movement at a sewn seam) for apparel, upholstery and stretch woven fabrics (including elastomeric yarns). The standard defines specimen preparation, sewing conditions, the test principle (fixed load applied by a CRE tensile machine) and reporting requirements so manufacturers and test labs can quantify seam opening under load.

Key topics and technical requirements

• Scope: Applies to woven apparel and furnishing fabrics; not intended for industrial fabrics (e.g., belting).
• Test principle: A folded, stitched fabric strip is clamped in a constant-rate-of-extension (CRE) machine and loaded; the width of the seam opening is measured at the widest point.
• Specimens and sewing:
  • Specimen size: cut to 200 mm × 100 mm (long side aligned to warp or weft to test both directions).
  • Fold and stitch with the seam 20 mm from the fold; cut 12 mm from the seam through both layers.
  • Stitch type: lockstitch type 301 (needle + bobbin thread). Thread, needle and stitch density requirements are specified in the standard.
• Test equipment & settings:
  • CRE tensile testing machine with metrological confirmation per ISO 10012 and force-measuring accuracy per ISO 7500-1.
  • Gauge/clamp separation set to 100 mm; constant rate of extension nominally 50 mm/min (tolerance given in the standard).
  • Clamp area and jaw-face requirements are defined to prevent specimen damage or slippage.
  • Data acquisition: minimum sampling frequency specified for force recording.
• Measurement & reporting:
  • After reaching the prescribed load, reduce to 5 N and immediately measure seam opening to the nearest millimetre.
  • Report mean warp and weft seam opening, maximum force applied, number of failures, specimen identification and any deviations.

Applications and users

ISO 13936-2:2004 is used for:

• Quality control and incoming inspection by apparel and upholstery manufacturers.
• Product specification and comparative performance testing (fabric selection, seam system evaluation).
• R&D and failure analysis of sewn textiles (assessing thread, stitch and seam design).
• Textile testing laboratories and certification bodies who provide objective seam-slippage data for contracts and standards compliance.