ISO 3465:1975 PDF
Hand taper pin reamers
Hand taper pin reamers
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Количество страниц:
- 2
- Дата публикации:
- 1 августа 1975 г.
- Издание:
- ISO IS 3465 edition 1 version 1
- ICS:
- 25.100.30
Lays down only metric dimensions, which are the only recommended dimensions in the future for these types of reamers. The reamers habe been designed to produce holes for taper pins manufacured to ISO 2339 in the range 0,6 to 50 mm nominal diameter. Unless otherwise stated, these tools will be rigth-hand cutting. The flutes may be straight or spiral at the option of the manufacturer.
Abstract
Overview
ISO 3465:1975 establishes international standards for , specifically focusing on metric dimensions as the recommended sizing method for the future. This standard applies to reamers designed to produce precise holes for taper pins manufactured according to , covering nominal diameters ranging from 0.6 mm to 50 mm.
Похожие стандарты
Стандарты, упомянутые в описании