ISO/TR 10358:2021 PDF

This document collects available data on combined chemical resistance of thermoplastic materials typically used to manufacture piping components for industrial applications, against fluids over a range of temperatures. The base thermoplastic materials covered by this classification are: Polyethylene PE NOTE 1 The PE considered in this document corresponds to PE-HD, with a minimum density value of 0,935 g/cm3 (e.g.: PE63, PE80, PE100, PE100-RC, PE-RT). Polypropylene PP (PP-R and PP-RCT, PP-H, PP-B) Polyvinyl chloride, unplasticized PVC-U Polyvinyl chloride, chlorinated PVC-C Polybutylene PB Acrylonitrile/butadiene/styrene ABS Polyvinylidene fluoride PVDF NOTE 2 This document considers homopolymer PVDF. Cross-linked polyethylene PE-X (PE-Xa, PE-Xb, PE-Xc) Ethylene chloro trifluoro ethylene ECTFE Polyamide, unplasticized PA-U (PA-U11, PA-U12) NOTE 3 This document focuses on PA-U11 and PA-U12 only, as these long chained PA-U are standardized according to ISO 16486-1; short chained (e.g. PA 66) and plasticized PAs are not used for monolithic plastic piping components. Polysulfone PSU Perfluoralkoxy PFA NOTE 4 Temperatures higher than 200°C can be applied after an evaluation with the raw material manufacturer. Polytetrafluoroethylene PTFE NOTE 5 Temperatures higher than 200°C can be applied after an evaluation with the raw material manufacturer. Polyphenylene sulphide PPS NOTE 6 PPS is new with regards to industrial application and chemical resistance issues; for this reason, manufacturers and end-users are advised to assess the chemical suitability of the material.