SIST EN ISO 11469:2016 PDF
Plastics - Generic identification and marking of plastics products (ISO 11469:2016)
Plastics - Generic identification and marking of plastics products (ISO 11469:2016)
- Статус документа:
- Действующий
- Формат:
- Электронный (PDF)
- Количество страниц:
- 11
- Дата публикации:
- 8 ноября 2016 г.
- Издание:
- ISO 11469:2016
- ICS:
- 83.080.01
ISO 11469:2016 specifies a system of uniform marking of products that have been fabricated from plastics materials. Provision for the process or processes to be used for marking is outside the scope of this International Standard. NOTE 1 Precise details of the marking, e.g. the minimum size of the item to be marked, the size of the lettering, the appropriate location of the marking, are subject to agreement between the manufacturer and the user. The marking system is intended to help identify plastics products for subsequent decisions concerning handling, waste recovery or disposal. Generic identification of the plastics is provided by the symbols and abbreviated terms given in ISO 1043‑1, ISO 1043‑2, ISO 1043‑3 and ISO 1043‑4. NOTE 2 If more detailed information for material identification is needed, additional marking of plastics products can be applied as defined in the appropriate product standard. ISO 11469:2016 is not intended to supplant, replace or in any way interfere with the requirements for labelling specified in product standards or legislation.
Abstract
Overview
SIST EN ISO 11469:2016, titled Plastics - Generic identification and marking of plastics products (ISO 11469:2016), is an international standard that establishes a uniform system for the identification and marking of plastics products. Published by SIST and harmonized throughout Europe, this standard helps manufacturers and users clearly identify the types of plastics used in products, facilitating efficient handling, recycling, and disposal.
The standard applies to plastics products fabricated from a wide range of polymers, blends, and composites, but explicitly leaves the details of the marking method (such as minimum size, lettering size, or precise marking location) to be agreed upon between manufacturer and user. Importantly, the marking system defined by ISO 11469:2016 supports generic plastics identification by using standardized symbols and abbreviated terms as detailed in ISO 1043 series. This helps simplify plastics sorting and recycling throughout the supply chain.
Key Topics
- Uniform Marking System: Establishes a consistent way to mark plastics using symbols or terms set between “greater than” and “less than” signs (e.g., `>ABS
Технические детали
- Технический комитет
- IPMA - Polimer materials and products
- SKU
- SIST EN ISO 11469:2016
Похожие стандарты
Упомянутые в описании и другие стандарты SIST